Idea Statica
  • Staal
  • Beton
  • Ondersteuning & Leren
  • Prijzen
  • Bedrijf
  • Overzicht staal
  • Verbinding ontwerp
  • Staafontwerp
  • Parametrisch ontwerp
  • Casestudies staal
  • Overzicht beton
  • Wand & detailontwerp
  • Concrete casestudies
  • Ondersteuningscentrum
  • Persoonlijke opleiding
  • Blog
  • Downloads & Licenties
  • Plannen
  • Gratis community tool
  • Licentie voor ondernemingen
  • Studenten en Universiteiten
  • Calculators
  • Over ons
  • Contact
  • Onderzoek & ontwikkeling
  • Blog
  • Evenementen
  • Staal
    Overzicht staalVerbinding ontwerpStaafontwerpParametrisch ontwerpCasestudies staal
  • Beton
    Overzicht betonWand & detailontwerpConcrete casestudies
  • Ondersteuning & Leren
    OndersteuningscentrumPersoonlijke opleidingBlogDownloads & Licenties
  • Prijzen
    PlannenGratis community toolLicentie voor ondernemingenStudenten en UniversiteitenCalculators
  • Bedrijf
    Over onsContactOnderzoek & ontwikkelingBlogEvenementen
14-daagse proefperiode
14-daagse proefperiode

Abonneer u op onze nieuwsbrief

Bedrijf

  • Over ons
  • Partnerschappen
  • Vacatures
  • Gepatenteerde technologie voor constructeurs

Bronnen

  • Klantprojecten
  • Case studies
  • IDEA StatiCa Connection Library
  • Verificatieboeken

Juridisch

  • Gebruiksrechtovereenkomst IDEA StatiCa
  • Wereldwijd privacybeleid
  • Terms of Services – IDEA StatiCa Viewer
  • Licenties

Help

  • Contact
  • Offerteaanvraag
  • Resellers
  • Downloads
FacebookInstagramLinkedInYouTube

© IDEA StatiCa 2009-2026

Vertrouwd en wereldwijd gebruikt door ingenieurs, fabrikanten & consultants.

OndersteuningscentrumKennisbank ArtikelenBoundary conditions on related member
Boundary conditions on related member
Member designSteelKnowledge baseMemberAISC (USA)

Boundary conditions on related member

The definition of boundary conditions is one of the most difficult tasks of modeling in any software. IDEA StatiCa Member works with part of your structure which is “cut-off” from your global 3D FEA model. Therefore, the program lets the definition of boundary conditions on the judgment of an engineer.

In IDEA StatiCa Member you can define boundary conditions at the ends of related members. The application offers to input:

a) Supports – definition of supports should correspond to your 3D FEA model

b) End forces on related members – correspond to internal forces calculated in the standard 3D FEA program

It is not possible to input only End forces on related members without using supports. A more precise model (e.g. local eccentricities of members, real lengths of members are taken into account ) is used. Thus the imposed imperfections for the GMNIA analysis cause that the equilibrium is not preserved and mechanism may, therefore, be defined.

Reasonable support based on structural engineer judgment is recommended.

c) Supports + End forces on related members – minimal reasonable supporting based on structural engineer judgment + add internal forces from your 3D FEA program.