Connecting RHS with through-bolts

This article is also available in:
IDEA StatiCa Connection allows designing nearly anything. But some connections are non-standard and cannot be checked by simple general checks provided by codes implemented in IDEA StatiCa. One of them is RHS connection with through-bolts. How to design them?

This article is based on a paper by Jason McCormick

Through-bolts are an alternative to blind bolts, hollo bolts, flow-drill bolts, or other special types of fasteners. They are easy to come by; threaded rods, nuts, and washers are all that is needed. However, the design and assembly have to be carefully thought through.

First of all, the bolts cannot be preloaded and even the snug-tight bolts must be tightened very carefully so that the hollow section is not flattened. 

Second, the bolts do not undergo the typical failure mode when loaded in shear. The check of bolts in shear is not valid and through-bolts must be designed as pins.

Third, the plates are not gripped by bolt and may cripple. Their resistance in bearing is decreased compared to a typical bolted connection.  

These facts have to be considered in the design and the respective checks in IDEA StatiCa Connection replaced.

Become a certified connection design professional

Ready to master analysis, design, and code-check skills of various steel connections for everyday engineering practice? Our online course can help you

Try idea statica for free

Download a free trial version of IDEA StatiCa